Tutorial on Men's Hair Systems Including Instructions on How to

  • It is necessary for us to leave some room in between each tape because when you wash your hair in the bathtub, there needs to be a way for water to escape the hair system. Therefore, we need to leave some space between each tape. Therefore, if you are just a tape and there are no gaps around you, the water will lean on the tape and eventually enter under the tape to make it softer. After that, it will flow along your head, and it won't stay on your head for very long. Simply leave some gaps between each piece of tape so that air can get in and out of your head while also allowing water to drain out. This is necessary for two reasons.

     

     

     

    Because you obviously need to use glue on the front because it needs to be transparent and it needs to fix the strap to make it look natural, that is why I use tape on the edge and glue on the front to ensure that you push the tape well. Because it needs to be transparent and it needs to fix the strap to make it look natural. When you are satisfied that they have been properly pressed down, you can then use your nails to separate one corner of the tape from the other side of the tape. The next step is to place it atop our respective heads. Therefore, I recommend that you begin by applying some hand sanitizer that contains a high percentage of alcohol to your scalp, and then you should ensure that it is completely dry by using a blow dryer on your hair. Also, before applying this, make sure that everything is totally dry, as it will not adhere to the scalp as effectively as it should if there is any water present in the mixture. The hand sanitizer is only going to help dry any grease or residue that is on the scalp, and it is only going to make sure that it is really as dry and ready as possible, so that when we apply it, it will adhere to the scalp as effectively as possible.

     

     

    This is what people comment on when they see the hairline on the back of your head, in addition to the width of approximately one finger. Once you are content with it, you can push it to the front part, and then use a little tension to ensure that it is tight and there are no bubbles in it. This is the natural position where your hairline starts, so make sure it is in the middle, and make sure it is in the right position. You can begin by gradually rolling it from front to back, and after doing so for a few minutes, you can take some time to press it onto your scalp. Because it is obviously stuck everywhere, appears to be very messy, and does not lie in the way that I want it to, the next thing I need to do is add some water to the spray bottle.

    I want my hair to lie flat against my head, so it needs more water because it tends to cling to my scalp. After that, I apply a small amount of conditioner because it helps soften my hair and makes it so that I can comb it more easily. Finally, I use a brush or comb that has a relatively wide toothed comb, a delicate brush, or anything else you can find that has as little mane as possible. This helps my hair look its best. Starting from the bottom of your hair guide and working my way up will make it much simpler for me to maneuver through it. This is simply to assist in the untying of some knots. If you feel like you need a little bit more conditioner, make sure that it is good, good, and smooth before you add it.

    Because I want it to sit back in this manner, if you want, I will dry my front hairline back, so you need to consider the direction of the hair dryer to ensure that you push it in the right direction as you want, because obviously, if you push it in the opposite direction as you want, it will not lie down correctly. If you want, I will dry my front hairline back. I also like its style because it allows your hair guide to hang down easily in the front. This is important because it allows you to see what you are doing more clearly if your hair is not hanging down, so once it is completely dry, it should appear as shown here. If you want to pull off that look, your hair needs to be gorgeous and silky, and it needs to be kept well away from your face. Because there is no hair in the way, however, it makes it much simpler for you to stick it down because you are able to clearly see what you are doing and there is no hair in the way. Just by giving it a quick brush, I can make sure that all of the knots are removed.

    You are free to smooth the hairline at the front down. OK, now move on to the next step: the hairline should be facing downward before you glue it, so I used gold sponge glue, and I also used a small brush with a flat end. Therefore, it is imperative that you ensure that all of the hair is pulled back, and that none of it will hang down. Because it is obvious that any gel will stick the hair together, and it will be very messy if you use a lot of it, our plan is that we don't want there to be any big glue. We hope that it will be beautiful and smooth.

    Because the neo system is a hairline in the shape of a shape, which obviously retreats a little to both sides and reaches a point in the front, so once we paint one, I will give it about 10-15 seconds until it is completely transparent, there should be no white part, and then we will go in and paint it again to scrape all your hair back. Well, I prefer to glue rather than glue, because you have to go back again and add more glue, To ensure that it is stuck atYou don't want it to get stuck in the glue because that would make things very untidy. Then repeat the previous step, but this time spread it out. I won't get too close to the point on the edge of your hair because I discovered that it is a kind of sweat and moisture, and there are some other factors involved. I'll just stay a safe distance away. You run the risk of appearing to be a greasy point at the very end. The next step is to walk away from it for approximately one minute. What happens is that the glue starts to become very sticky. When it starts to dry, we need to grasp it when it is at its stickiest point in order to prevent it from falling apart.

    Therefore, I roll the brush into glue using the opposite end of the brush.

    This is going to be a very time-consuming endeavor for me. There is no need to be concerned about any Virgin hair styling getting stuck in the glue. You will see in a few minutes that it has a poor appearance, but we will fix it in the future. At this point, the most important thing that needs to be done is to make sure that all of the hair is completely adhered to the scalp. This is because any space in the Virgin hair styling is the point where it will begin to detach from your head once more. Therefore, we are keeping our fingers crossed that it will indeed adhere to the front, and after that, I will give it at least five minutes to dry. Now you understand what I meant by the pieces stuck in the glue when I described them earlier. Although it will result in an unnatural appearance at the hairline, it is best to keep it in place. After that, we use some solvent remover and some kitchen rolls. Simply spray a little bit more solvent remover onto the kitchen roll to ensure that you are using the kitchen roll and not the paper towel or the cotton pad.

    Oh my God, if you use the paper towel or cotton pad in the kitchen, you will be aware of all of this information. Your hairline will be covered in white fluff, and it will be extremely challenging to remove it. Make sure you use the kitchen roll because it won't tear into pieces, and all you have to do is gently rub it along the hairline and forehead to remove any remaining glue. To achieve a more natural appearance, I simply pull the  forward while I'm doing it, and then I pull it out of the glue. This helps the hair look more like it came from a natural place. My hair is very straight because I always brush and dry it before styling it. This is the haircut that I like best. It looks less straight and more natural when it has a little bit of natural wave in it, so I really like it when it does that. As you can see, this is my hair.